Make sure the coating side of the ribbon is face down. Making a Keyboard Form 1. Printing job will start until the temperature of TPH goes down. Do not connect this pin if you use a general host such as a PC. Click Cancel and do not install the driver using this wizard. To change setting to ribbon would ink-side out, refer to Section – Switching Ribbon Wound Ink-side out or Ink-side in 1.

Uploader: Sazilkree
Date Added: 12 February 2018
File Size: 15.1 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 50561
Price: Free* [*Free Regsitration Required]

The following installation steps are based on X as an example. The control knobs can rotate to both directions.

A label is printed. Remove the outside media guide. Do not change settings during printing or sending printing data. The X industrial barcode printer features dpi argos for high quality text and graphics on fabric labels, safety labels and labels for small items such as jewelry. If the printer supports Plug-and-Play, and you have successfully connected it using a USB cable, then the Windows Add Hardware Wizard will automatically detect the printer and display a dialog that allows you to install a driver.

Plug the power cable into the power socket on the wall, and then connect the other end of the cable to printer’s power socket.


Argox X |

Attach the edge of the ribbon onto the bare core and wind it a bit onto the core. When using a keyboard or barcode reader communicating with a host z-3200 the Centronics or serial port is prohibited.

Check whether you have received the following accessories together with the printer. Open the left cover of printer. Hold both buttons zrgox about 3 seconds and release.

Memory full Check graphics and soft fonts from host. For unstable ribbon roll rotation, check the label path and make sure the head latch is securely closed. Lead the ribbon through the print head module. Loose the three screws from Tear-off Bracket and then remove Tear Bracket. These indicators display operation status of the printer.

Scan product name and number from printed bar codes using the barcode reader.

Remove the top cover on both left and right sides. For technical and pin-out information, please refer to the Technical Reference in this manual. The X provides outstanding value as it delivers industrial strength high quality printing for a wide range of labels. Blinking — Ribbon is used out; install new argoox.

The emulation is a printer programming language through which the host can communicate with your printer.


Then release the buttons to enter settings. Make sure the coating side of the ribbon is face down.

ARGOX X-3200

Argoc sure the peeler sensor is out of the ribbon path when installed. It is applicable with printer models: The viewing direction is facing the machine, and using hex socket screw driver for the adjustment. Then select proper settings via Seagull Driver for printer. Isolate the power cord from other electrical cables. Once it happens, rotate counter-clockwise control knob of ribbon supply, to increase ribbon tension to balance the tension.

Repeat aryox necessary until the cotton is clean after it is passed over the head.

Click Cancel and do not install the driver using this wizard. Push down the peel-off mechanism release lever and lead the media under the peeler module. Related questions Dear Sir, Can i connect directly to Argox ppla printer using php?