On VREF no voltage higher than 3. It converts streamed data to CSV output that can be stored on disk or network. ADC Touch screen is disabled. Other terms and product names may be trademarks of others. Usually cross-compiler-prefix- looks like arm-linux- , arm-elf- or arm-none-linux-gnueabi-. How the ADC stores its data.

Uploader: Akizshura
Date Added: 16 November 2013
File Size: 55.71 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 51259
Price: Free* [*Free Regsitration Required]

Streaming is stopped when the device is closed. We recommend to remove the 0Ohm R21 resistor and provide an external 3.


This patch adds ADC driver’s source. You can also specify the buffer length to use 2 in this example.

The device uses a double buffering technique and supports blocking as xtmel as non-blocking read and poll. It could be either u for unsigned or s for signed 10 is the number of relevant bits of information 16 is the actual number of bits used to store the datum 0 is the number of right shifts needed.

Linux Kernel Driver DataBase: CONFIG_AT91_ADC: Atmel AT91 ADC

The driver can be compiled as module using option ‘M’ to enable the driver in menuconfig that atme be loaded via insmod. Up to four channels Selectable resolution of eight or ten bit Single measurements Data streaming Applying the patch In order to use the driver kernel sources need to be patched. Connect to LinksToCommunities page. Terms of use of this documentation.


Ten bit measurements result in streams with 16 bit channel data. Please note that the setup of the timer counters in themselves is not achieved by this driver, so you will have to do it yourself. Acme Systems srl provided this ah91 “as is” without warranty or guarantees of any kind.

Documentation for this Linux subsystem is available in the kernel source code directory: Other terms and product names may be trademarks of others. The pins for the two last channels won’t be multiplexed as ADC outputs, and the channels won’t be available in the driver.

All material on this collaboration platform is the property of the contributing authors.

drivers/iio/adc/atsama5d2_adc.c – Welcome to AT91SAM Community Discussions

StampA5D36’s little brother is coming. How the ADC stores its data. In case of sharing please indicate the origin: Please note that conversions are done one channel at a time. In this way the max sample resolution we obtain is about 3. A stream of four channels at eight bit would look like: First, load the driver: Originally used as test program during driver development it offers some features that won’t be expected in a sample program.

The first step is to get the Linux kernel: In either case, the conversion is started on rising edges. Maximum thoughput is limited by conversion time, meaning trigger frequency is not equal to output frequency in all cases. How to set it up Basically, what you should do for launching the hardware triggers is: Reading this file should return you a weird looking string.


It is a simple linear trimmer 1Kohm but any value is ok with the central cursor wired to J4. Software Triggers Software triggers are an ADC operating mode where the software starts the conversion.

The shipping office is closed from 21 dec up to 7 jan Once this device file is opened the ag91 starts continuous measurements on all enabled channels with respect to selected resolution and frequency. We not provide any direct support for the Open Source software which can running on our board but, through these pages and forum posts, we provide all of the information required to obtain the sources, install, use and update the Open Source software available on Internet.